error in rebuild command

[amirtaghavi]

Hello Dr. Xiangjun,

following the example in "np_recipes/R2_roll_bending" I am trying to use the rebuild command to create an image like those provided (Figure3_r300.png) for my RNA systems which are highly bent.

After preparing the input file to execute the following commnad:
 rebuild roll_a.dat roll_a_raw.alc
I receive an error message: unknown residue slide

so I just ran the same command on the example file provided in the "R2_roll_bending" dir (roll_a.dat) and I get the same error message.

I was wondering if I could use your help.

Thanks in forward.

Best,
Amir

[xiangjun]

Hi Amir,

3DNA has been completely superseded by DSSR. Due to a lack of funding support, I can no longer devote any effort on 3DNA.

DSSR Pro is the only software product I support right now. A video overview of DSSR is available at: http://docs.x3dna.org/dssr-overview/

Best regards,

Xiang-Jun