Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Netiquette · Download · News · Gallery · Homepage · DSSR Manual · G-quadruplexes · DSSR-Jmol · DSSR-PyMOL · DSSR Licensing · Video Overview· RNA Covers

Messages - eholzhauser

Pages: [1]
1
RNA structures (DSSR) / Re: Redirect Auxiliary File Output
« on: May 13, 2016, 03:20:47 pm »
I apologize for the late reply, but my issue was resolved with the last revised DSSR!

Thanks,
Erwin

2
RNA structures (DSSR) / Re: Redirect Auxiliary File Output
« on: May 13, 2016, 11:37:16 am »
I downloaded the Linux 64-bit compiled version on the Downloads page. I still get the same error: "open_file failed: Permission denied".

Thanks for the continued help,
Erwin

3
RNA structures (DSSR) / Re: Redirect Auxiliary File Output
« on: May 13, 2016, 10:32:27 am »
I'm using CentOS Linux release 7.2.1511.

Thanks again,
Erwin

4
RNA structures (DSSR) / Re: Redirect Auxiliary File Output
« on: May 12, 2016, 04:00:54 pm »
Dr. Lu,

That fit the bill, thank you!

I have a follow-up question, but it may be too ambiguous. Do you know what could cause DSSR to send "open_file failed: Permission denied" to the error stream? I'm assuming DSSR needs read permission to the directory where the input PDB / mmCIF structure is, and read/write permission to the directories where output / auxiliary output are created. When I run the JAR that calls DSSR on my server from the CLI, everything works fine--the auxiliary files and output go where I expect them to. However, when I execute the JAR from the web interface that I'm building, I get that message from DSSR. The web interface runs with permissions set up for Apache, so somewhere, I haven't given Apache the appropriate permissions that I have as a user of the server. So, I am wondering where all I should take care to give DSSR appropriate read/write permissions.

Thanks again, and sorry for the wall of text,
Erwin

5
RNA structures (DSSR) / Redirect Auxiliary File Output
« on: May 12, 2016, 02:50:03 pm »
Hello Dr. Lu,

I was wondering if there is a command to redirect the output of the auxiliary files used by DSSR?

I'm developing a web server for RNA 3D structure alignment and am using DSSR for base-pairing annotation. Currently, DSSR always creates the auxiliary files in the directory from which DSSR is called. In my case, DSSR is called by a JAR file in a directory where I don't want to allow write permissions.

Thank you,
Erwin

Pages: [1]

Funded by X3DNA-DSSR, an NIGMS National Resource for Structural Bioinformatics of Nucleic Acids (R24GM153869)

Created and maintained by Dr. Xiang-Jun Lu, Department of Biological Sciences, Columbia University