3DNA Forum

Questions and answers => MD simulations => Topic started by: xroxzero on November 08, 2017, 11:14:05 am

Netiquette · Download · News · Gallery · G-quadruplexes · DSSR-Jmol · DSSR-PyMOL · Video Overview · DSSR v2.5.1 (DSSR Manual) · Homepage

Title: about "curavture" and "tangent" in dnaMD
Post by: xroxzero on November 08, 2017, 11:14:05 am

Hello,

I have a question about the unit of "curavture" and "tangent" in dnaMD. 

In dnaMD, my dna contains 24bp, and I type " dnaMD vsTime -i 24bp_dna.h5 -tbp 24 -bs 1 -be 24 -p "curvature" -mm sum -o curvature.dat ".

An error occur, "The requested end bp 24 is out side of 1-23 range" , why the range is 1-23?

This error occur on "tangent" ,too.

Also,I concern the unit of "curavture" and "tangent" ?



Thank you very much for your help,
Anderson

Title: Re: about "curavture" and "tangent" in dnaMD
Post by: Rajendra Kumar on November 08, 2017, 12:02:40 pm

Hi,

As written in tutorial (http://do-x3dna.readthedocs.io/en/latest/notebooks/helical_axis_tutorial.html), axis coordinate is determined using two base-pairs (one base-step) by 3DNA. Therefore, number of helical-axis coordinates is less than one of total number of base-pairs.

Unit of helical-axis is A, therefore, curvature unit is (1/A). Tangents are a list of vectors with same as helical-axis unit.

With regards,
Rajendra

Funded by the NIH R24GM153869 grant on X3DNA-DSSR, an NIGMS National Resource for Structural Bioinformatics of Nucleic Acids

Created and maintained by Dr. Xiang-Jun Lu, Department of Biological Sciences, Columbia University